The piping has to be sized, installed and tested correctly. If you smell gas right now, leave the house and call your gas utility from outside.
The utility comes first, checks for a leak and shuts off the gas if needed. Once they've made it safe, call us. We repair the piping or appliance connection so the gas, and usually the heat, can go back on. If you're left without heat, see no heat.
Gas piping we install and repair
Gas work sits with our heating team, because most gas piping in a Rhode Island house feeds a boiler, furnace or water heater. We install and repair natural gas and propane piping inside and outside the home.
Kitchen and laundry
New lines for ranges and cooktops, and gas dryer hookups.
Water heaters
Gas supply for water heaters, including upsizing for a tankless conversion.
Generators and outdoor lines
Piping for standby generators, grills, fire pits and pool heaters.
Repairs and testing
Leaking fittings, valves and flexible connectors, missing shutoff valves, and pressure testing existing piping.
Gas piping for restaurants, rooftop units and new construction is handled by our commercial plumbing team.
Adding an appliance or swapping one
Adding a new appliance
Switching a range or dryer from electric to gas, or adding a generator, means running a new line from your existing piping. The question is whether your gas service and pipe sizes can carry the added load.
Replacing an existing one
A like-for-like swap often needs only a new connector and shutoff. A larger appliance, like a tankless water heater or bigger generator, may need a larger line back to the meter.
Gas piping is sized for the total demand of every appliance on it and the distance from the meter. Undersized pipe starves appliances. A generator may not start, or a tankless heater may shut down mid-shower.
Before running a new line we add up the load and check your existing piping and meter. If the gas service needs an upgrade, that goes through the utility, and we'll tell you what to ask them for.
Signs the piping needs attention
- An old, uncoated brass flexible connector behind a range or dryer
- A yellow, lazy flame instead of steady blue
- An appliance that won't light
- Dead or brown grass along an outdoor gas line
Old uncoated brass connectors should be replaced. A gas smell or a hiss isn't on this list because it isn't a wait-and-see problem. If you smell gas, leave the house and call your gas utility from outside.
How a new line goes in
Look at the route
New lines are priced on site once we've seen the route from the gas source to the appliance. An open basement ceiling is straightforward. Finished space or an outdoor run takes longer.
Run the piping
Flexible CSST has to be bonded, which may involve an electrician.
Test and connect
We pressure test the piping, connect and light the appliance and check every joint for leaks.
Inspection
New gas piping needs a permit and is inspected before it goes into service.
Towns we cover most
We install and repair gas lines throughout Rhode Island, including West Warwick, Warwick, East Greenwich and North Kingstown.