If none of them work, call and we'll get a technician to you.
Five checks before you call
Plenty of no-heat calls turn out to be simple. Check these in order. None of them need tools.
The thermostat
Set it to heat, not cool or off, and turn it a few degrees above room temperature. A blank screen usually means dead batteries. That's one of the most common no-heat calls we get.
The power switch and breaker
The emergency shutoff, often a switch with a red plate at the top of the basement stairs, gets flipped off by people who think it's a light. Make sure it's on, then check the panel for a tripped breaker labeled boiler, furnace or burner.
Boiler pressure
On a hot water boiler the gauge should read roughly 12 to 15 psi cold for most homes. Near zero means the system is low on water. Don't add water yourself unless you know the system.
The reset button, once
Oil burners and some gas boilers have a red reset button. Press it once. If the burner doesn't run, don't press it again. Each press on a failed oil burner sprays more oil into the chamber, which can flood it or cause a puff back.
Oil level and furnace filter
Gauges stick, so if the oil tank reads low, it probably is. Call your oil company. A burner that ran dry usually needs to be bled and restarted. On a furnace, a gray, caked filter can cause an overheat shutdown, so swap it for a clean one.
Still cold? Call if any of these apply
- You smell gas, or exhaust in the basement
- The boiler is leaking water
- The pressure gauge is near zero or very high
- The burner tried once on reset and failed
- The unit is banging, screeching or rumbling
- It's near freezing outside and the house is dropping fast
Day or night
We're available 24/7, and no heat in winter is a real emergency, so it gets a response day or night. When you call, we tell you when we can realistically get there. Have your system type ready (boiler or furnace, gas or oil) and tell us what you already checked.
What the technician does
The technician starts at the thermostat and works toward the burner, checking power, controls, fuel supply, pressure and venting until the cause turns up. The usual suspects are an igniter, a circulator pump, a clogged oil nozzle or filter, a thermocouple or flame sensor, a stuck zone valve or a control board.
You get the price before we start, including for an after-hours visit. If a part has to be ordered, we tell you when to expect it and whether there's a safe way to get some heat in the meantime.
For the first hour, see the heat went out at 2am. For ongoing problems, see boiler repair or furnace repair.
Towns we cover most
We take no-heat calls across Rhode Island, including West Warwick, Coventry, Warwick and West Greenwich.