24/7 emergency service. Call now
PlumbPro Plumbing and Heating, West Warwick RI
Contact Us

Boiler, Furnace and Heat Pump Tune-Ups in Rhode Island

A yearly tune-up keeps your heating system running safely and catches worn parts before they fail.

  • Licensed since 2017
  • Residential & commercial
  • 24/7 for emergencies

Here's what we check on each type of system.

Fixing it in October beats fixing it in January

A clogged oil nozzle, dirty flame sensor, weak capacitor or flat expansion tank all show up on a tune-up before they cause a breakdown.

A tune-up is a scheduled maintenance visit, not a repair call. We clean and test the system and tell you about anything that's wearing out.

Oil systems benefit most. Oil leaves soot, and a sooty boiler burns more fuel for the same heat. Many oil equipment manufacturers recommend yearly service.

What we check, by system

Every tune-up includes a safety check. The rest depends on what heats your house.

Hot water and steam boilers

Clean the burner and combustion chamber, test combustion and adjust the burner. Oil: new nozzle and filter, strainer and pump pressure. Gas: igniter, flame sensor and gas pressure. Then the pressure gauge, expansion tank, relief valve, circulators, zone valves and near-boiler piping. On steam, the sight glass and a flush and test of the low water cutoff.

Gas and oil furnaces

Clean the burner and flame sensor, check the igniter and gas valve or service the oil burner, and inspect the heat exchanger for cracks or rust. Check the blower, capacitor and belt, clear the condensate drain on high efficiency units, test the limit switch, and check or replace the filter.

Heat pumps and mini splits

Clean the indoor filters, coil and blower wheel as needed, clear the outdoor coil, and check refrigerant pressures, electrical connections and the capacitor. Test the defrost cycle and heat mode, and clear the condensate line.

Every visit

Test the thermostat and confirm the system heats to setpoint. Check venting and test for carbon monoxide. Explain anything that's worn, and price any repair so you can decide now or later.

Boiler with clean copper supply and return piping Near-boiler piping and valves get looked over on every boiler tune-up.

When to schedule

Early fall is best for boilers and furnaces, before you need heat every day. Heat pumps and mini splits run year round, so spring or fall works. More in boiler tune-up timing.

How much does a boiler tune-up cost?

It depends on the system type and fuel. Oil boilers take longer than gas because of the nozzle and filter change, and multi-zone ductless systems take longer than a single head. We can tell you the price when you book.

Is it too late for a tune-up in December?

No. If you missed the fall, a winter visit still catches a clogged nozzle or a weak part before the coldest weeks.

Do heat pumps need yearly maintenance?

Yes. Dirty filters and coils, a clogged drain line or a weak capacitor cut both heating and cooling performance, and a yearly visit catches them.

What happens if you find a problem?

The technician goes over what they found at the end of the visit. If something is wearing, you hear how urgent it is and what it costs to fix now or later.

For repairs, see boiler repair or furnace repair.

Towns we cover most

We do heating tune-ups across Rhode Island, including West Warwick, Coventry, Warwick and Scituate.

Not sure what you need?

Describe what you’re seeing and we’ll tell you whether it’s a quick fix or a bigger job.

Call us
Call 401-773-5000