Most of it gets fixed from the front, without touching your tile.
Most shower problems start at the valve
A shower that drips after you shut it off, or swings hot when someone flushes, is almost always telling you something about the valve behind the handle. Often the fix is a new cartridge.
We handle the plumbing side of showers and tubs:
- Valve repairs and replacements, and diverters
- Drains, overflows and leaks into the ceiling below
- Tub and shower base replacement
- The plumbing for tub-to-shower conversions
- New shower heads, hand showers and tub fillers
A tub or shower that drains slowly is usually a clog. See drain cleaning.
What you might be noticing
- The shower or spout keeps dripping after you shut it off
- The water goes hot or cold when someone uses another fixture
- The handle is stiff, loose or spins without shutting off
- Water keeps coming out of the spout with the shower on
- A stain on the ceiling under the bathroom
- Cracked tile, loose grout or soft spots around the base
- A crack in a fiberglass or acrylic tub or base
New cartridge or new valve?
A new cartridge or stem
Fixes most drips and temperature swings. It's done from the front without opening the wall, and if it solves the problem, that's what we'll recommend.
A new valve
Makes sense when parts for the old valve aren't made anymore, or the valve body is corroded or leaking inside the wall. It's also worth it if you have an old two- or three-handle setup with no scald protection, or the tile is coming off anyway. We replace it with a single pressure-balancing or thermostatic valve.
The tub or base itself needs replacing when it's cracked, leaking at the drain because the base flexes, or too worn to come clean. A cracked fiberglass base keeps leaking no matter how often it's caulked.
Tracking down a leak below the bathroom
A stain under a bathroom can come from the valve, the shower arm, the drain, the overflow, or splash water getting past old caulk or grout. We test before we open anything.
Run the shower with the drain closed
This tests the valve, the shower arm and the supply side.
Run it with the drain open
Now the drain connection is carrying water, so a drain leak shows itself.
Fill the tub to the overflow
This tests the overflow gasket, a common and easy-to-miss source.
Open only what the repair needs
When a wall has to come open, we try to go in from a closet or the ceiling below so you keep your tile. More on tracing leaks in leak repair.
How replacements are priced
A cartridge or drain gasket is usually one service call. Valve and tub replacements are quoted on site, and you get a written estimate listing the parts and what we need from you, like the trim finish.
The big variables are access behind the valve, tile repair and getting the old tub out. Cast iron tubs often have to be broken up to get them out of the room.
If rotted subfloor or a corroded drain turns up under an old tub, we stop and show you before going further.
Towns we cover most
We work on showers and tubs all over Rhode Island, including West Warwick, Warwick, East Greenwich and Scituate.