We repair steam and hot water boilers across Cranston, and you get the cause and the price before any work.
Which system do you have?
A lot of Cranston heats with boilers, and the type depends heavily on when the house was built.
Edgewood and Pawtuxet Village
Early 1900s homes with cast iron radiators, some on steam and some on hot water.
Garden City and Eden Park
Mid-century capes and ranches, usually with hot water baseboard.
Western Cranston
Newer houses with high-efficiency boilers, radiant floors or several zones.
It helps to know which you have before you call. A steam radiator has a small vent sticking out the side near the top, and the boiler has a glass sight tube showing the water level. A hot water radiator has a small bleed valve instead, and the boiler has a pressure gauge.
Steam radiators in the older neighborhoods
Steam is simple and long-lived, but it's particular. Most of the problems we fix on Cranston steam systems are outside the boiler. Banging usually means water trapped in a pipe that's lost its slope. A cold radiator usually has a stuck or painted-over air vent. Both are fixable, and neither means you need a new boiler.
Hot water baseboard in the mid-century houses
On hot water systems, a cold zone is usually a seized circulator or a stuck zone valve. Pressure that climbs until the relief valve drips usually means the expansion tank has lost its air charge. Gurgling means air in the lines. These are the most common boiler repairs we make, and most don't mean the boiler is finished.
Old chimneys and carbon monoxide
Older boilers in older Cranston chimneys can vent poorly, especially after the chimney has been shared, lined or partly abandoned when another appliance moved off it. We check the venting on every boiler call, not just the burner.
What a repair visit looks like
We find the cause
We check the burner, controls, water level or pressure, venting, and the pumps and valves on the system.
You get the price
You hear what failed and what it costs before any work starts.
We fix it and run it
We make the repair, run a full heating cycle and check every zone or radiator.
If the heat exchanger is leaking or the boiler has needed major parts season after season, we'll show you the cost of replacement next to the cost of repair, and you decide. For homes without ductwork that also want cooling, mini-splits can run alongside an existing boiler.
Cranston boiler questions
Why does my boiler keep losing pressure?
There's a leak in the system or the relief valve is opening. Look for water at the boiler, along the baseboard or at radiator valves, and let us know what you find.
Should I drain my steam boiler?
A weekly low water cutoff flush is normal on some older steam boilers; check the label or ask us. Don't drain the whole boiler yourself.
Can I add zones to an old hot water system?
Often, yes. It depends on the boiler, the piping and how the house is laid out. We'll look at it and tell you what's practical.
If the whole house is cold right now, start with no heat. Boilers that also heat your water are covered on water heater repair in Cranston, and the rest of our work in the city is on the Cranston page.