24/7 emergency service. Call now
PlumbPro Plumbing and Heating, West Warwick RI
Contact Us

Boiler Repair in Providence, RI

Radiators that bang, a sight glass that jumps, or a building where the top floor is cold and the first floor is roasting.

  • Licensed since 2017
  • Residential & commercial
  • 24/7 for emergencies

Steam heat is common in older Providence buildings, and we repair it.

Steam heat needs someone who understands it

A lot of Providence's older housing was built with steam heat, and plenty of it still runs on the original radiators. Steam works differently from hot water. The boiler makes steam, the steam rises through the pipes to the radiators, gives up its heat, turns back to water and drains back down to the boiler.

Every part of that loop depends on the right water level, working vents and pipes pitched the right way. When someone works on a steam system as if it were hot water, it usually gets worse. Our HVAC lead is master licensed, with more than 10 years of experience leading a commercial HVAC division, and steam is part of the job.

What steam problems sound and look like

Banging or knocking pipes

Usually water trapped where steam is trying to pass. A sagging pipe, a radiator tilted the wrong way or a water level set too high.

Cold radiators

Often a stuck or painted-over air vent that won't let air out, so steam can't get in.

A jumping sight glass

Water bouncing in the gauge glass can mean dirty boiler water or a near-boiler piping problem.

Short cycling

The boiler fires, stops and fires again. Pressure settings, a dirty pigtail or a low water cutoff are common causes.

Constantly adding water

A steam boiler that needs frequent refilling is losing water somewhere: a leak in a return line or in the boiler itself.

Hot water boilers too

Not every older Providence building is on steam. Many were converted to hot water over the years, and newer renovations often have a wall-hung gas boiler with a zone for each unit. Those calls are about circulators, zone valves, air in the lines and the boiler's own controls. Our main boiler repair page lists what we work on.

How a boiler call goes in a multi-family

  1. Find out who's cold

    One cold unit points to a zone, vent or thermostat. A cold building points to the boiler.

  2. Check the boiler and the system

    Water level, pressure, controls, burner and safety devices on the boiler, then the vents, piping and radiators that actually heat the rooms.

  3. Price it before the work

    You'll hear what failed and what the repair costs before we start. If something else needs attention, we show you.

  4. Talk about the long run

    If the boiler has years left, we say so. If it's near the end, we'll give you repair and replacement numbers side by side.

Providence boiler questions

Why do my steam radiators bang?

Water is sitting where steam needs to flow. A pipe has lost its pitch, a radiator isn't sloped back toward its valve, or the boiler water level is set too high. It's fixable once we find which.

Should I convert my steam system to hot water?

Sometimes it's worth it, sometimes it isn't. A well-maintained steam system can heat a building evenly for a long time. We'll explain what a conversion involves in your building and let you decide.

Why is one apartment cold when the rest are warm?

On steam, it's often air vents or piping pitch on that unit's radiators. On hot water, it's usually a zone valve, circulator or thermostat.

If the heat is out entirely, start with our no heat page. A boiler that also makes your hot water through an indirect tank is covered on water heater repair in Providence. For the rest of our work around the city, see Providence.

Not sure what you need?

Describe what you’re seeing and we’ll tell you whether it’s a quick fix or a bigger job.

Call us
Call 401-773-5000